SU-16 Follower

Back to Kel-Tec stuff

Origonaly posted by StevenTapia on KTOG.

Ok so I am sure most of you have seen those cool orange followers for the AR mags, right? Well I got some in for my High Caps, but had a bunch of spares. I modified two of the followers to fit my 10 round factory mags! The job requires slight thinning of the rear follower guide and shorting the spacers on the bottom to Factory specs. BE CAREFUL if you try this. It is real easy to make one too short and this would constitute an Illegal 11 round mag! IMHO. I did not make the mistake as I used my veneer caliper to measure the factory spacer.